Uniswap governance has given unanimous voting-weight support to an offchain temperature check that would extend the protocol's v4 fee system to five additional networks. The vote closed on November 21 at 18:30 UTC with 27.9 million UNI in favour, none against and none abstaining, according to the Uniswap proposals interface. The displayed participation rate was 17%. The result advances the proposal, but it does not activate fees or complete the governance process.

Five networks would join the v4 rollout

The proposal covers Celo, Soneium, X Layer, World Chain and Zora. Uniswap Labs said v4 protocol fees are already active on Ethereum, Arbitrum, Base, OP Mainnet, BNB Chain, Polygon, Robinhood Chain and Arc. Adding the remaining five networks where earlier protocol versions already collect fees would place every fee-active deployment under the same v4 framework. The proposal explicitly excludes third-party-developed hooks.

Related reporting: Uniswap v4 Adds External Liquidity Routing Across Three Chains

Existing TokenJar and release infrastructure on the five networks would collect protocol fees and connect them to the approved UNI burn process. The governance post says UNI burned on those chains is bridged to Ethereum and sent to the designated burn address. That mechanism does not mean every v4 pool will immediately pay the same amount: the adapter applies governance-defined rules, and pool family, liquidity-provider fee settings and any overrides can affect the result.

Arbitrum adjustment travels with the proposal

A sixth action would change the target liquidity-provider fee for two USDC/USDG StablePair pools on Arbitrum. The tick-spacing-1 pool would move from 0.5 basis points to 0.07 basis points, while the tick-spacing-2 pool would move from 0.08 to 0.07 basis points. Uniswap Labs said only the optimal-fee setting would change. The adjustment concerns the pools' LP-fee target and should not be confused with the separate protocol fee.

Why the temperature check is not final

Uniswap's expedited process allows fee-parameter proposals to move from a five-day Snapshot vote to an onchain vote without a separate request-for-comment stage. Before that final vote, the upgraded V4FeeAdapter and policy contracts must be deployed on the five networks, with ownership checked against the relevant cross-chain accounts. The expansion also depends on the companion adapter-upgrade proposal. Uniswap Labs said the forum post would be updated with final contract addresses and explorer links once deployments are ready.

Who could be affected

For traders and liquidity providers, the practical effect will depend on the pools they use. Uniswap's documentation says v4 protocol fees are additive to the trader-side fee, unlike the v2 and v3 approach that reallocates part of an existing swap fee. Integrators will need to confirm adapter settings and effective fees by network and pool rather than assuming one global rate. UNI holders are also exposed to how much value the fee-and-burn system actually collects after activation.

What to watch next

The decisive evidence will be a published onchain proposal, final deployment addresses, executable payloads and the subsequent vote result. Delegates may also review audits and cross-chain message paths before voting again. Even unanimous voting weight in a temperature check does not represent every UNI holder or guarantee execution. If the proposal ultimately passes and is executed, post-activation data will be needed to show fee revenue, changes in trading costs, liquidity effects and the amount of UNI burned across the five networks.

Sources

AI-generated editorial image; not a photograph of the reported event. Prepared with AI assistance and source verification.